The Arty family of Digilent FPGA/SoC boards was designed with versatility and flexibility in mind. With universally popular Arduino headers and multiple Pmod ports, an Arty will be the most adaptable FPGA/SoC board in your toolbox.

The Arty Z7 is a ready-to-use development platform designed around the Xilinx Zynq-7000 System-on-a-chip (SoC) family. The Zynq-7000 SoC family integrates the software programmability of an ARM-based processor with the hardware programmability of an FPGA, enabling key analytics and hardware acceleration while integrating CPU, DSP, ASSP, and mixed signal functionality on a single device.

The Arty Z7 is supported by Xilinx’s Vivado Design Suite, including the free WebPACK version. The SDSoC Development Environment provides a familiar embedded C/C++/OpenCL application development experience for heterogeneous Zynq SoC deployment.

There are two variants of the Arty Z7: The Arty Z7-10 features the XC7Z010-1CLG400C, and the Arty Z7-20 features the larger XC7Z020-1CLG400C. There is a third option available, the Arty-Z7-20 with a Xilinx SDSoC voucher, which is recommended for those interested in video processing applications.

• ZYNQ Processor
• 650MHz dual-core Cortex-A9 processor
• DDR3 memory controller with 8 DMA channels and 4 High Performance AXI3 Slave ports
• High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
• Low-bandwidth peripheral controller: SPI, UART, CAN, I2C
• Programmable from JTAG, Quad-SPI flash, and microSD card (Micro B USB cable NOT included).
• Programmable logic equivalent to Artix-7 FPGA
• Memory
• 512MB DDR3 with 16-bit bus @ 1050Mbps
• 16MB Quad-SPI Flash with factory programmed 48-bit globally unique EUI-48/64 compatible identifier
• microSD slot
• Power
• Powered from USB or any 7V-15V external power source
• USB and Ethernet
• Gigabit Ethernet PHY
• USB-JTAG Programming circuitry
• USB-UART bridge
• USB OTG PHY (supports host only)
• Audio and Video
• HDMI sink port (input)
• HDMI source port (output)
• PWM driven mono audio output with 3.5mm jack
• Switches, Push-buttons, and LEDs
• 4 push-buttons
• 2 slide switches
• 4 LEDs
• 2 RGB LEDs
• Expansion Connectors
• Two standard Pmod ports
• 16 Total FPGA I/O
• Arduino/chipKIT Shield connector
• Up to 49 FPGA Digital I/O for the Z7-20 and 26 FPGA Digital I/O for the Z7-10
• 6 Single-ended 0-3.3V Analog inputs to XADC
• 4 Differential 0-1.0V Analog inputs to XADC

Included:

• Arty Z7: SoC Development Board (Micro B USB cable NOT included)
• Digilent cardboard packaging with protective foam